This position serves as a journey-level Electrician within any organizational unit of the National Park Service (NPS). The primary purpose of this position is to perform a variety of journey-level electrical work needed to install, modify, repair, maintain, troubleshoot, test, and/or load new and existing electrical lines, circuits, systems, and associated fixtures, controls, and equipment..
To qualify for this position, you must have sufficient knowledge and ability in the following job-related factors: Ability To Do The Work Of The Position Without More Than Normal Supervision (SCREEN OUT) Ability To Use and Maintain Hand Tools (Electrical Work) Ability To Use Electrical Drawings Knowledge of Electrical Equipment Technical Practices (theoretical precise, artistic) Theory and Instruments (Electrical, Electronic) Used in Shop and Trade Practices Trouble shooting (electrical) If your knowledge and ability in the SCREEN OUT factor above is not sufficient, you will receive no further consideration. In preparing your application, describe in detail the experience and training which you have had that specifically prepared you for this job and to perform the duties described for this job. Experience should be clearly described and documented in your resume. The qualifications reviewer will not assume performance of such duties by Job Titles alone. Address your knowledge, skills and/or abilities in the areas shown in the job-related factors. Volunteer Experience: Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., Peace Corps, AmeriCorps) and other organizations (e.g., professional; philanthropic; religious; spiritual; community, student, social). Volunteer work helps build critical competencies, knowledge, and skills and can provide valuable training and experience that translates directly to paid employment. You will receive credit for all qualifying experience, including volunteer experience.
Performs all preventative maintenance, operational checks, repair, layout, installation, troubleshooting, tracing, locating defects, modification on all new and existing electrical systems park wide, electrical generators and fire suppression systems park wide. Installing and troubleshooting meters, load centers, circuit breakers, equipment controls, lighting and power outlets, disconnects, solenoids, relays and lighting fixtures. Plan and lay out the routing, placement, type and size of wire. Tests and balances electrical loads Locate distribution panels, boxes, circuits, fixtures, transformers and other electrical devices. Work from plans, blueprints, wiring diagrams, engineering drawings, repair manuals and related codes. Physical Demands: This position is required to perform electrical work from ladders, scaffolds, platforms, and other cramped and hard-to-reach places. Duties require the incumbent to sit, stand, stoop, bend, kneel, climb, crawl, and work in uncomfortable positions. The incumbent may be exposed to electrical shock, spark and arc hazard, and other health hazards. If the incumbent is assigned to perform electrical work in remote locations, the incumbent may be required to walk, hike, or drive over rough and uneven terrain. The incumbent is expected to lift and/or carry items up to 50 pounds, and occasionally exceeding 50 pounds in weight. Working Conditions: Work is both indoors and outdoors. Work outside may be subject to extreme weather conditions, with wind, rain, snow, and ice, in temperatures ranging from below 0 to over 100 degrees. Depending on the geography of the park unit assigned, work may take place at elevations ranging from sea level up to 10,000 feet. The incumbent may be regularly exposed to dust, fogs, mists, gases, smokes, sprays, and vapors, as well as noise, vibration, cuts, and abrasions from the use of electrical tools and equipment and may occasionally be exposed to hazardous materials that can cause skin, eye, and respiratory irritation and burns, as well as microbiological organisms and potentially hazardous wildlife. The incumbent is expected to comply with all safety and occupational health requirements and wear protective clothing, gloves, face shields, and in some cases a respirator that may be uncomfortable.